Browsing Category Uncategorized
-
Uncategorized
MHPS’s T-Point 2 enters commercial operation with 60 Hz gas turbine
MHPS’s T-Point 2 combined cycle power plant validation facility entered full commercial operation with an enhanced JAC gas turbine, which the company says set the record for output ...
-
Featured Story
The bad and good news in the gas turbine market
Just as we were about to hear some better news about the gas turbine market at the Western Turbine Users Conference, the world was turned on its head ...
-
Uncategorized
Tweaks the gas turbine needs for offshore use
Offshore projects are characterized by requirements that are not encountered in onshore projects. Such issues shall be well considered in the design of gas turbines and their auxiliary ...
-
Uncategorized
Cleaning pipelines with steam blowing
As centrifugal machines, run with very close clearances at very high RPM, even a small foreign particle can have devastating effect. It is always recommended to ensure cleanliness ...
-
Uncategorized
Mechanical run test of a compressor
Mechanical run test of a compressor is a vibration demonstration test. Mechanical testing provides information related to the critical speed location and some indication of that modes behavior. ...
-
Uncategorized
Controlling compressor performance by varying process variables
The ultimate goal of compressor performance control is to match the compressor delivery to the process demand. This is achieved by varying the compressor throughput, which is why ...
-
Uncategorized
Prompt NOx, fuel NOx and thermal NOx: The DLE strategy
NOx is a generic term for the oxides of nitrogen, NO and NO2. All that is required to form NOx is to bring air to very high temperature, ...
-
Featured Story
GT AIR FILTRATION
THREE MAJOR PROPERTIES DIFFER FROM ONE FILTER TO ANOTHER. THE TECHNOLOGY USED IMPACTS UPTIME AND OPERATING COSTS BY MIKE ROESNER Caption: Inlet guide vanes (left) after 1,200 hours ...
-
Uncategorized
Newsletter reader gives feedback on turbomachinery installation
Ronald E. LeTard, P.E. of Cypress, Texas writes in: “A recent newsletter article on Turbomachinery Installation stated that the sleeves around the anchor bolts should be filled with ...
- 1
- 2
- 3
- …
- 7
- Next Page »
Turbomachinery Magazine brings you the latest and most comprehensive news and perspective in the industry.
| There are no products |